Komatsu — REPLACE FUEL PRE-FILTER CARTRIDGE

2. Open the cover on the right side of the machine. 3. Set the container to catch the fuel under the pre-filter cartridge. 4. Remove connector (2). Wrap the removed connector in a vinyl bag to prevent water from getting on it. 5. Using a filter wrench, turn transparent cap (3) to the left to remove it. (This cap is used again.) 6. Using a filter wrench, turn cartridge (4) to the left to remove it. 7. Install transparent cap (3) to the bottom of the new filter cartridge. (When doing this, always replace O-ring (5).) 8. When installing, bring the packing surface into contact with the seal surface of filter cartridge (4), then tighten a further 1/4 -1/2 turns.

MAINTENANCE If the transparent cap is tightened too much, the O-ring will be damaged and this will cause leakage of fuel; if it is not tightened enough, fuel will leak through the gap at the O-ring. To prevent these problems, always tighten securely to the fixed tightening angle. 9. Clean the filter holder, fill the new filter cartridge with clean fuel, coat the packing surface thinly with oil, then install to the filter holder. When adding fuel, do not remove cap (B). Always add fuel from the 8 small holes (A) on the dirty side. After adding fuel, remove cap (B) and install the fuel filter. Always fill with clean fuel. Be careful not to let any dirt or dust get into the fuel.

In particular, center portion is the clean side, so do not remove cap (B) when adding fuel. Be careful not to let dirt or dust get into center portion on the clean side. 10. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the filter car- tridge is too loose, fuel will also leak from the packing, so always tighten the correct amount. When tightening with a filter wrench, be extremely careful not to dent or damage the filter. 11.

Check to be sure the drain plug at the bottom of transparent cap (3) is tightened securely. 12. Remove the vinyl bag covering connector (2), then connect connector (2). Remark If water gets on the connector (2), the sensor may malfunction and the water separator monitor may light up. When removing connector (2), be extremely careful not to let water get on the connector. If water gets on connector (2), dry it completely before connecting it. 13. Turn valve (1) at the bottom of the fuel tank to the left to open it. 14. After completing the replacement of filter cartridge (4), bleed the air. PC300LC/HD-7E0 3-53