MAINTENANCE EVERY 1000 HOURS MAINTENANCE Maintenance for every 250 and 500 hours service should be carried out at the same time. REPLACE FUEL MAIN FILTER CARTRIDGE After the engine has been operated, all parts are at high temperature, so do not replace the filter immedi- ately. Wait for all parts to cool down before starting the operation. High pressure is generated inside the engine fuel piping system when the engine is running. When replacing the filter, wait for at least 30 seconds after stopping the engine to let the internal pressure go down before replacing the filter. Do not bring any fire or flame close. Be careful when opening the air bleed plug in the filter head.
It is still under pressure and fuel may spurt out. Genuine Komatsu fuel filter cartridges use a special filter that has highly efficient filtering ability. When replacing the fil- ter cartridge, always use a genuine Komatsu part. The common rail fuel injection system used on this machine consists of more precise parts than the conventional injection pump and nozzle. If any part other than a genuine Komatsu filter cartridge is used, dust or dirt may get in and cause problems with the injec- tion system. Always avoid using substitute parts. When carrying out inspection or maintenance of the fuel system, pay more attention than normal to the entry of dirt.
If dirt is stuck to any part, use fuel to wash it off completely. Container to catch the oil Filter wrench 1. Turn valve (1) at the bottom of the fuel tank to the right to close it. 2. Set the container to catch the fuel under the filter cartridge. 3. Using a filter wrench, turn filter cartridge (2) counterclockwise to remove it. 4. Clean the filter holder, coat the packing surface of the new filter cartridge thinly with oil, then install the filter cartridge to the filter holder. Remark Do not fill the new filter cartridge with fuel. Remove cap (B) and install the filter cartridge. PC300LC/HD-7E0 3-61