Komatsu — REPLACE FUEL MAIN FILTER CARTRIDGE

MAINTENANCE 5. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be dam- aged and this will lead to leakage of fuel. If the filter cartridge is too loose, fuel will also leak from the packing, so always tighten the correct amount. 6. Turn valve (1) at the bottom of the fuel tank to the left to open it. 7. After completing the replacement of filter cartridge (2), bleed the air. Bleed the air as follows: 8. Add fuel to the fuel tank until full (to FULL mark on the fuel gauge). 9.

Insert the key in the ignition switch and turn the key to the ON position (B). The electric priming pump is actuated. 10. Hold the key at the ON position (B) for 30 seconds, then return it to OFF position (A) and wait for 10 seconds. 11. Repeat Steps 9 and 10 four times. 12. After replacing the filter cartridge, start the engine and check for leakage of fuel from the filter seal surface. If any fuel is leaking, check the tightening condition of the filter cartridge. If there is still leakage of fuel, repeat Steps 1 - 3 to remove the filter cartridge, and check the packing surface for damage or embedded foreign material.

If the packing is damaged or there is embedded foreign material, replace the car- tridge with a new part and repeat Steps 4 - 12 to install. 3-62 PC300LC/HD-7E0