MAINTENANCE REPLACE HYDRAULIC OIL FILTER ELEMENT The parts and oil are at high temperature immediately after the engine is stopped, and may cause burns. Wait for the temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. If the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket operations. 1. Set the work equipment on the hard and flat ground in the mainte- nance posture as shown in the figure, then lower it to the ground and stop the engine. 2. Remove the cap from oil filler (F), and release the internal pressure. 3.
Loosen 6 bolts, then remove cover (1). When doing this, the cover may fly out under the force of spring (2), so hold the cover down when removing the bolts. 4. After removing spring (2), valve (3) and strainer (4), take out element (5). Inspect the bottom of the filter case for dirt, and remove it, if any. Take good care then not to let fall the dirt into the hydraulic tank. Remark If the mounting bolts of cover (1) loosened in Step 3 are left for approx. 5 minutes, the internal pressure inside the case will be released, so if the element is removed when the oil in the element has drained out, the amount of dripping oil will be reduced. 5. Clean the removed parts in diesel oil. 6.
Install the new element in the place where old element (5) was installed. 7. Set valve (3), strainer (4) and spring (2) on top of the element. 8. Set cover (1) in position, push it down by hand, and install the cover with the mounting bolts. 9. Screw in the oil filler cap and install the cover. 10. To bleed the air, start the engine and run the engine at low idle for 10 minutes. 11. Stop the engine. Remark Wait for at least 5 minutes after stopping the engine to eliminate bubbles in the oil inside the tank. 12. Check for oil leakage and wipe off any spilled oil. PC300LC/HD-7E0 3-63