Komatsu — CIGARETTE LIGHTER

OPERATION IGNITION SWITCH This switch (1) is used to start or stop the engine. -OFF position The key can be inserted or withdrawn. The switches for the electric system except the room lamp, are all turned off and the engine is stopped. -ON position Electric current flows in the charging and lamp circuits. Keep the ignition switch key at the ON position while the engine is running. -START position This is the engine-start position. Keep the key at this position during cranking. Immediately after starting the engine, release the key. It will automatically return to the ON position. -HEAT (preheat) position When starting the engine in winter, set the key to this position.

When the key is set to the HEAT position, the pre-heating monitor lights up. Keep the key at this position until the monitor lamp flashes. Immediately after the pre-heating monitor flashes, release the key. The key automatically returns to the OFF position. Then, start the engine by turning the key to the START position. ENGINE SPEED CONTROL DIAL This dial (2) is used to control the engine speed and output. A. Low idle (min) ....... Turned fully to the left (counterclockwise) B.

High idle (max)................Turned fully to the right (clockwise) Remark Even if the fuel control dial is turned several notches up from low idling position (a) or down from full speed position (b), there is a range where the engine speed does not change, but this is not an abnormality. CIGARETTE LIGHTER This switch (3) is used when lighting cigarettes. When the cigarette lighter is pushed in, it will return to its original position after several seconds. Pull it out to use it. If the cigarette lighter is removed, it can be used as the power source for the yellow hazard lamp. The capacity of the cigarette lighter is 85 W (24 V x 3.5 A). 2-34 PC300LC/HD-7E0