SWING LOCK SWITCH OPERATION When traveling or when not using the swing operation, apply the swing lock. On slopes, even when the swing lock switch is at the ON position, the weight of the work equipment may cause the upper structure to swing if the swing control lever is operated in the downhill direction. This switch (4) is used to lock the upper structure so that it cannot swing. LAMP SWITCH This switch (5) is used to light up the front lamps, working lamp, additional lamp at the top front of the cab, rear lamp, and monitor lighting. MACHINE PUSH-UP SWITCH This switch (6) is used to switch the safety valve set pressure at the head end of the boom cylinder to two levels.
(a) Low-pressure setting: The boom thrust force is weak, so the swaying of the chassis is small during digging operations, and digging operations can be carried out smoothly. This is used for general digging operations on normal ground, soft rock, or blasted rock. (b) High-pressure setting: The thrusting force of the boom becomes more powerful, so it is easy to escape from soft ground. PC300LC/HD-7E0 2-35 ON position (actuated): The swing lock is always applied, and the upper structure will not swing even if the swing is operated. In this condition, the swing lock lamp lights up. OFF position (canceled):
The swing lock is applied only when all the control levers of the work equipment are at neutral; when any one of the control levers is operated, it is cancelled. The swing lock is actuated approximately 5 seconds after all the control levers are placed in the neutral position.