Komatsu — EMERGENCY PUMP DRIVE SWITCH

OPERATION HORN SWITCH When the button (7) at the tip of the right work equipment control lever is pressed, the horn will sound. POWER MAX SWITCH Switch (8) is located (top one) on the left work equipment control lever is used to actuate the power max and slow down functions. Press once (single click) and keep the switch pressed. The one touch power max. function is actuated for a maximum of 8.5 seconds in P and E mode. CAB LAMP SWITCH Remark Be sure to switch the lamp to the OFF position after use. If the switch is left at the ON position, the battery will run down. This switch (9) is used to light up the room lamp.

ON position........................................................................Lights up OFF position.......................................................................Goes out It will also light up even when the engine is not running. EMERGENCY PUMP DRIVE SWITCH Remark This switch is installed to make it possible to carry out operation temporarily if any abnormality should occur in the pump control system. It is not intended for permanent use. Repair the cause of the abnormality immediately. This switch (10) is used to make it possible to carry out operations temporarily if any abnormality should occur in the pump control system (when the display shows E02).

When normal...................................................... Move switch down When abnormal....................................................... Move switch up If the display shows E02, move the switch up to make it possible to carry out work. 2-36 PC300LC/HD-7E0