. OPERATION OPERATION ADJUST SEAT BELT WARNING depress the brake pedal fully and back is pressed against the pull the belt on the right and (2) securely until it makes a ADJUST STEERING WHEEL TILT WARNING position. Amount of adjustment: Front/rear: 80 mm/80 mm (3.2 in/3.2 in) (from center of steering wheel) Up: 33 mm (1.3 in) Down: 17 mm (0.7 in) 3 - 83 The seatbelt is a protective device th at is designed to prevent you from hitting your head on the dash board or front glass if the machine suffers impact from the fron t during operations. If it is not used correctly, the seatbelt will not be able to perform its protective function and you may suff er serious injury. Always do as follows.
belt mounts are damaged or there are cuts in the belt. proper operating posture and adjust the seatbelt. wisted. Always replace the seatbelt if the Before starting to travel, sit in the Make sure that the seatbelt is not t Even if no abnormality can be seen in the seatbelt, replace the belt every three years. The date of ma nufacture is shown on the reverse side of the belt. Fastening and removing belt Fasten the belt so that it is tight w 1. 2. 3. 1. Sit in the operator's seat, de adjust the seat so that you seatback. Sit in the operator's seat, th 2. insert tongue (1) into buckl clicking sound. 3. To release the seatbelt, press The belt will be released.
Fit the belt so that it follows y Always stop the machine before a djusting the steering wheel tilt. If the steering wheel tilt is adju sted when the machine is traveling, it may lead to mistakes i n operation, which will cause serious personal injury. Always fix the steering wheel secu rely in position after adjusting the tilt. If the steering wheel is not fixed securely in position, the steering wheel position may s uddenly change during operation, and this may lead to mistake s in operation, which will cause serious personal injury. The tilt of steering wheel can be 1. Pull the lever up. Steering wh 2. Set the steering wheel colum 3. Push down the lever. The ste