. OPERATION OPERATION ADJUSTING MIRROR WARNING Rear monitor (if equipped): Must be possible to see hatched portion (H) 3 - 84 Be sure t o adjust t he mirrors before starting work. If they a re not adjusted properly, you cannot secu re the visibility and may be injured o r may inju re someone serio Loosen the bolt and nut installing the mirror, then adj ust the mirror to a pos ition whi ch gives the bes t view from the oper ator's seat. Adjus sight t the po 200 mm sition and angle above the gro of each mirror so th und and up to 150 at it reflects a 0 mm. In the adjustment, m ake sure that pa rt of the dump truck 's image also come s into vi Mirror A: Mus arou grou Mirror B: Mus Mirror C:
Mus of th Mirror D: Mus arou grou body Mirror E: Mus porti cont edge Mirror F: Must the machine Mirror G: Mus of the machin Mirror A: Mus t be possible to see hatched portion (A), area nd point (A') wh ere the tire contact s the ground, nd surface (A'') a nd the top edge of th e dump body Mirro r B:
Mus t be possible to s ee hatched portion t be possible to e machine t be possible to see hatched portion (D), area nd point (D') where the tire contacts the ground, nd surface (D'') and the top edge of the dump ere the tire contact s the ground, t be possible to see hatched portion (E), hatched on (D), area around point (D') where the tire acts the ground, ground surface (D'') and the top of the dump body on (D), area ar ound point (D') w acts the ground, of the dump bo Mirro r F: Must be possible to s ee hatched portion ( F) and part of the m achine Mirro r G: Mus t be possible to see hatched portion (G) and part of the machin e