Komatsu — METHOD OF TOWING MACHINE

. OPERATION TROUBLESHOOTING There are towing hooks under the front frame and under the rear axle. Do not use any other part for the towing hook. 3 - 138 This machine must no t be towed except in emergencies. When towing the machine, take the following precautions. When towing a mac hine, tow it at a low speed of less than 2 km/h (1.2 MPH), and for a distance of a few meters to a place where re pairs can be carried out. the machine should be towed only i n emergencies. If the machine must be moved lon g distance, transport the machine using the Trailer truck. ine of the same class as the machine being towed.

Use a towing mach Check that the towi ng machine has ample braking power, weight, and rimpull to a llow it to control both machines on slopes or on the tow road. ook for both the towing machine and the machine being towed. Use the specified h ook for both the towing machine and the machine being towe To protect the opera tor if the towing wire or towing bar breaks, install protective pla tes on both the towing machine and the machine be When fitting the tow ing wire, check the condition of the hook to make sure that th Keep the angle of t he towing wire as small as possible.

Keep the angle bet ween the center lines of the two machines to within 30 degre Towing may be car requirements for to Towing on flat hori surfaces will require If the pressure in a hydraulic circuit has dropped because of leakage of oil, the p arking brake will be applied, so release the parking brake before towing. Before releasing the parking brake, always put blocks under all four wheels. If the wheels are not blocked, there is danger that the m achine may move. Connect with the to wing wire or drawbar, and remove the blocks from the wheels when the disabled machine is in a condition wher e it cannot run away. parking brake, check first that the surrounding area is safe.

lly that the situation is safe. When releasing the When the parking b rake is released, the brakes cannot be used, so check carefu When towing down a slope, use two towing machines. One machine should be u phill from the disabled machine and should be conn ected with towing wire or a drawbar to pull the disabled machin e back and keep it stable. The other machine shou ld tow the disabled machine downhill.