. MAINTENANCE GUIDES TO MAINTENANCE PRECAUTION FOR FIRE: WARNING UNAUTHORIZED MODIFICATION: WARNING WELDING INSTRUCTIONS: WARNING 4 - 5 Do not bring any flame close to fuel, oil, anti freeze, or window washer fluid. There is danger th at they m ay ignite a nd cause a fire. Do not bring them close to any flame. If any of these fluids is spilled, wipe it up immediately. Do not smoke or use any flame clos e to fuel, oil, antifreeze, or window washer fl Do not start the engine when adding Do not leave the machine when addi ng fuel, oil, antifreeze, or window washer fluid. Alway s check th at no fluid has spilled during the filling operation.
e caps securely to prevent any fuel or oil from spilling. on hot surfaces or on parts of the electrical system. e spilled fuel and oil with a cloth. After adding fuel or oil, tighten all th e caps securely to prevent any fuel or oil from spillin Be extremely careful not to spill fuel on hot surfaces or on parts of the electrical system. After adding fuel or oil, wipe up all th After wiping up fuel or oil with a clot h, put the cloth and other flammable substances in t he specifi ed container, and store the container in a place w here there is no danger of the contents catching fire . Use a non-flammable oil as the fluid f or washing parts.
Do not use fuel, gasoline, o r any ot her fluid th at may c atch fire. ipes or tubes that carry flammable fluids. m in a place where there is good ventilation. Do not weld or use a gas cutter on p Fuel and oil evaporate, so keep the Always store the fuel and oil in the s pecified place and within the maximum specified am ount. Do not allow any unauthorized person to enter the ar ea. When carrying out grinding operation s or welding operations on the machine, mov e the m achine to a place w here there is no danger of any substance catching fire. Do not to carry out any unauthorized modific ation of the machine.
If the machine is modified, pr oblems may occur with safety , and thi s may lead to serious personal injury. Be fore making any modification, always consult you r Komat su distribut or. Consult your Komatsu distributor regar ding modifications. If you carry out modifications with out consulting anyone, the machine may not function properly and problems may occur with safety. All welding operations should be carried ou t by a qualified welder with the proper equipment. During welding op erations, g as is generated, and there is danger of fire and e lectrocution. Never allow any unqualified person t o carry o ut welding operations. Turn off the engine starting switch. nuously.
m (3.3 ft) of the area to be welded. If grounding cable is connected near struments may malfunction. Do not apply more than 200 V conti Connect grounding cable within 1 instruments, connectors, etc., the in If a seal or bearing happens to come between the part being welded and groundi ng point , change t he grounding point to avoid such parts. or the hydraulic cylinders as the grounding point. ted portion. Do not use the area around the pins or the hydraulic cylinders as the grounding Sparks will cause damage to the pla