Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE the ON start. 4 - 39 4. Operate position . Lamp (4 ) will flash and th e electric p riming p REMARK tric priming pump switch has a built-in timer, and this actuates and stops the pump automatically. e lamp is flashing, the electric priming pump will stop, but this does not indicate any abnormality. The elec tric primin g pump switch h as a built-in timer, a nd this a ctuates and stops the While th e lamp is f lashing, the elec tric priming pump wi ll stop, b ut this does not indica If the swi tch is turn ed to the OFF po sition when the lamp is lighte d up, the lamp will go o ut and the electric priming pump wi ll stop. 5.

When t he specifi ed time (approx. 7 minutes) has passed, lamp (4) automatically goes out and the electric ps. priming pump sto 6. If the fu el has bee n drained from t he fuel circuit, such as when the engine has run o ut of fuel and stopped, or maintenance has been carried ou t on the fuel hoses o r tubes, or the supply pump ha s been replaced, turn the switch f or the elec tric priming pum p to the ON position again aft er the electric priming p ump stops automatically (lamp g oes out). oes out, the air bleed operation is completed. 7. When t he lamp g oes out, the air b leed operation is co mpleted.