Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE BLEED AIR FROM REAR BRAKE WARNING TRANSMISSION CASE, ADD OIL (PAGE 3-71)". 4 - 41 When bleeding the air, the brakes are released, so the machine may move a nd cause serious personal i njury. When carrying out the air bleed operation, always park t he machine on level ground and put b locks To make it easier to bleed the air , warm the oil up to a temperature of at l east 40°C (104°F) b efore bleeding the air. Bleed the air from the rear brake s in the same way on both the left and 1. Start the engine. 2. Check that the oil in the trans mission case is the specified level, and c heck if the brake oil pressure caution lamp is out. Remove the cap installed to 3.

adjuster, then insert a vinyl h Prepare a container with oil in hose approx. 50 mm (2.0 in) 4. (Use any commercially avail Depress the brake pedal and 3/4 turns. Keep the pedal d come out from the vinyl hose 5. Pull the retarder control leve approx. 3/4 turns. Keep the until no more bubbles come 6. After bleeding the air, tighten bleeder screw (1) securely and fi t the 7. The procedure for bleeder s same as for the slack adjuste 8.