Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE EVERY 500 HOURS SERVICE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING hose in general yourself, and drain the excessive metal your Komatsu (7 ± 1 kgm, 50.6 ± 7.2 lbft) 4 - 64 Maintenance for e very 250 hours service shou ld be carried out at t Immediately after th e engine is stopped, the oil and p arts are at high temperature, so there is danger of suffering burns during the operation. Wait for t he temperature to go down befo re starting the operatio n. Refill capacity: Prepare a filter 1. Remove drain tool. 2. Set a containe r in position to catch the oil, th valve (2) slow ly to avoid getting oil on you oil.

Be carefu deform the st l not to loosen drain valve (2) opper pin inside the valve. 3. Check the d particles or f distributor. 4. Remove the d rain hose, then tighten drain plug (1). Tightening tor Drain plug (1), drain valve (2): 68.6 ± 9.8N Using the filter left to remove When doing th out this opera In particular, i is, to prevent getting oil on y tion from immediately under f this operation is carried ou stopping the e ngine, a large amount of oil w for 10 minutes before starting the operatio 5. Clean the filte r holder, fill the new filter car coat the seal and thread of the filter cartri ase) and install. thinly with gre 6.

When installin g the filter cartridge, tighten until the packing fac e is in contact with the f ilter holder, then tighten a further 3/4 - 1 turn. ecified amount of engine oil from oil filler (F). e for a short time at idle, then check the oil if it is filled up to a specified level. For details, see LEVEL IN ENGINE OIL PAN, ADD OIL (PAGE 3-70)". 7. Pour in the sp ecified amount of engine oil 8. Run the engin e for a short time at idle, th "CHECK OIL LEVEL IN ENGINE OIL PAN , ADD OIL (PAGE 3