Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE the inside of the filter 4 - 66 5. Clea n transparent cup ( 3) and remove seal (4). Coat the new seal with clean fuel or o 6. Insta ll transparent cup ( 3) to the new filte r cartrid Tightening torque for cu p: 10 Nm {1.0 kgm, 7.2 l t is not ne cessary to fill the filt er cartridge with oil. Cap (A) is cartridge. Whe n replacing the filte r cartridge, check that dra in plug (5 ) at the b ottom of transpare nt cup (3) is securely tigh tened. (Tightening torque: 0.2- 0.4 Nm {0.02 - 0.046 kgm, 0.1 - 0.3 lbft} 7. 8. Clea Coat 9. 10.

Remove filter cartridge When installing, tighten cap (A) and instal until the packing l to the surface filter hold contacts seal surface of the filter holder, then tighten it 3/4 of a turn If the filter cartridge is tightened too far, the pa of fuel cking wil l be damaged and this will lead to leakage . If the f ilter cartridge is too loose, f alwa ys tighten the corre 11. Open fuel valve (1) on t