Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK WEAR OF FRONT DISC BRAKE PADS WARNING 1. Install the inspection gauge (2) into the wear inspection hole (1). 2. Check clearance between inspection gauge stepped portion (3) of gauge and caliper (4). The wear limit where stepped portion (3) of gauge (2) contacts pad (5). (A):Near wear limit (B):Wear limit reached, so replace pad Left and right wheels are not always the same in terms of the 4 - 70 Check the wear of th e disc brakes carefully. If the disc exceeds the wear limit , the braking distance wil l become longer and it may become impossible t o stop the machine within the de sired distance. Th is may lead to serious person al injury.

Perform inspection EVERY 250 HOURS if the w ork site is covered by lots of earth and sa nd if it is at the location where the foot bra caliper (4) is 3 mm (0.1 in) (remaining thickness o f pad), so repla After the inspectio n, if it is necessary to change the pad, contac t your Komatsu distributor amount of wear of the pad. So, perform the insp ection for both l and right. If either side shows the wear limit, be s ure to change 8 If the work is perfo rmed on the muddy and wate ry ground, the mud sticks to caliper or dis increase the wear of pad, so wash out thoroughl y with water.