. MAINTENANCE SERVICE PROCEDURE CHECK, REPLACE COMPRESSOR DRIVE BELT FOR ALTERNATOR, AIR CONDITIONER tighten push bolt (3) 4 - 73 CHECKING If the alternator drive b elt is in any o f the following belt must b e replaced. When h orizontal scr atch (1) crosses vertical scratch (2) When th ere are tear s (3) in part o f the belt In case (4) where ther need to re place the bel only, there is no REPLACIN 1. Remo ve 8 bolts (1) , then remov e cover (2). Loose fully to n locknut (4) push in tens This w Replac Loose ill loosen bel e the belt. n push bolt ( appea rs, then tight en the locknu t (4) 5. Install cover (2), th en install 8 bo lts ( 1).