Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE 250 HOURS and EVERY 500 HOURS SERVICE at the same time. REPLACE CORROSION RESISTOR CARTRIDGE WARNING Prepare a filter wrench of water from the filter seal 4 - 74 EVERY 1000 HOURS SE Carry out maintenance for EV Immediately after the engine is st opped, the oil and parts are at high temperature, so there is dang er of suffering burns duri ng the operation. Wait for the temperatu re to go down before starting the o peration 1. Turn valve (1) on top of th e corrosion resister to close. 2. Set the container to catch the water under the cartridge. 3. Using a filter wrench, rem 4. Clean the filter holder, co cartridge with clean engin 5.

When installing, tighten surface of the filter holder until the gasket contacts , then tighten a further 2/3 If the filter cartridge is ti damaged and this will lead ghtened too far, the gasket w to leakage of water. If the filter ill be is too loose, water will also leak f rom the gap at the gasket, so al ways tighten the correct amoun 6. Open valve (1). After replacing the cartrid 7. heck there surface. If there is any lea kage of water, check the t ightening of the filter cartridge.