MAN — Man EPA07 MBE 4000 Engine Operator's Manual

EPA07 MBE 4000 OPERATOR'S MANUAL 1. Remove the vent cap, open the drain valve and drain fuel into approved container, until level is below the collar. See Figure 39. 10. Start the engine and raise the rpm for one minute to purge the air. After the air is purged stop the engine, loosen the vent cap until the fuel level lowers to just above the collar. Tighten the vent cap by hand. Check for leaks. 2. Using a collar wrench remove collar and cover. 3. Remove the filter element from the separator head and discard filter cover seal and vent seal. Dispose of filter properly. Replace Davco 382/382E Fuel Pro® Fuel Filter Element 4. Clean the cover and the mounting surface on the body.

The Davco 382/323E Fuel Pro diesel fuel filter system consists of a permanently mounted fuel processor, a replaceable filter element and sealing grommet assembly, a filter spring, a see-thru cover and seal, a cover collar, and a vent cap and seal. See Figure 40. 5. Install the filter element with bottom grommet and new cover seal. Install the cover and collar. Hand tighten only. 6. Fill cover completely with clean fuel through the vent cap opening. 7. Replace seal on the vent cap and install in cover. Hand tighten only. NOTE: Do not use tools to tighten the collar or vent cap. 8. Tighten the drain plug. 9. Crank the engine for 30 seconds at a time, but no longer.

Before cranking the engine again, wait at least two minutes. The engine should start within four, 30 second attempts. All information subject to change without notice. 93 DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION