MAN — Man EPA07 MBE 4000 Engine Operator's Manual

HOW-TO SECTION 3. A fuel shutoff valve may be installed on the discharge side of the fuel filter. If installed, turn the handle on the shutoff valve to the closed position (perpendicular to the valve). 4. Open the drain valve at the base of the fuel processor and drain the fuel until it is below the bottom of the filter in the see-thru cover. Close the drain valve. The fuel may be returned to the tank. 5. Using filter collar/vent cap wrench Davco part number 382002 or equivalent, remove the collar by turning counterclockwise. Remove the cover, filter spring and cover seal ring by lifting straight up and over the filter element. 6.

Remove the element from the center stud (fuel outlet pipe) by pulling upward and twisting slightly. Figure 40 Davco 382E Fuel Pro Fuel Processor Assembly The system also includes a fuel heater element, thermostatic switch and wiring harness. NOTE: Current filter elements include an integral sealing grommet. If a former element is replaced, make sure the separate sealing grommet is removed from the center stud before installing the new element. Replace the element as follows: 1. Shut down the engine and allow it to cool. 2. With the engine at ambient temperature and cool to the touch, place a suitable container under the filter. 7.

Dispose of the used element and grommet in an environmentally responsible manner, according 94 All information subject to change without notice. DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION