EPA07 MBE 4000 OPERATOR'S MANUAL to federal (EPA) and/or state recommendations. NOTICE: To avoid cover or vent cap damage, do not use tools to tighten the vent cap. 8. Check to make sure the sealing grommet is included in the base of the replacement filter element, then install the element onto the center stud by pushing down and twisting slightly. 12. Open the fuel shutoff valve (if installed) and start the engine. When the lubrication system reaches its normal operating pressure, increase engine speed to high idle for 2 to 3 minutes. 9. Check to make sure the spring is installed at the top of the cover. If missing, this spring must be replaced to insure proper filter operation.
Wipe the cover lip and cover seal clean. NOTICE: Do not allow the fuel level in the see-thru cover to fall below the top of the collar, since this may lead to interruption of the fuel flow and engine stalling. NOTICE: Do not use a wrench of any kind to tighten the collar, since this may lead to overtightening, which can damage the collar and/or the cover. 13. After the air is purged and with the engine still running, loosen the vent cap. The fuel level in the cover will start falling. When the fuel level falls to the top of the collar, tighten the vent cap quickly by hand . 10.
After making sure the seal is properly positioned at the base of the cover, install the cover and collar onto the fuel processor. Tighten the collar by hand until secure. 14. Shut down the engine and tighten the collar again by hand . Restart the engine and check for leaks. 11. Using filter collar/vent cap wrench 382002 or equivalent, remove the vent cap from the top of the cover by turning the cap counterclockwise. Fill the cover full of clean fuel. After making sure the O-ring seal is installed on the vent cap, reinstall the cap and tighten by hand . NOTE: The filter cover will not fill completely during engine operation.
It will gradually fill over time, and the fuel level will rise as the filter medium becomes clogged. The filter element All information subject to change without notice. 95 DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION