MAN — Man EPA07 MBE 4000 Engine Operator's Manual

EPA07 MBE 4000 OPERATOR'S MANUAL 8. Add coolant in the specified concentration until the maximum mark on the surge tank is reached. 1. Inspect the radiator, condenser, water pump, engine oil cooler, freeze plugs, and heat exchanger for damage and leaks. 9. Start the engine and run it for about one minute at varying speeds to release air pockets in the cooling system. Ensure the heater valve is still open. Check the coolant level and add more coolant if necessary. 2. Check all cooling system pipes and hoses for damage and leaks; ensure they are positioned to avoid chafing, and are securely fastened. 3. Check the outside of the radiator and condenser for blockage.

Check fins for damage; straighten them if necessary. 10. Shut down the engine, close and tighten the cap on the surge tank. Cooling System Inspecting NOTE: Before doing this inspection, do either "Coolant Concentration Checking," or "Coolant Flushing and Changing." Inspect the cooling system as follows: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. All information subject to change without notice. 117 DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION