MAN — Man EPA07 MBE 4000 Engine Operator's Manual

TROUBLESHOOTING TROUBLESHOOTING In addition to operating the engine carefully and maintaining it properly, make sure to correct any malfunction promptly. codes can be read using the Nexiq DDR or DDDL 7.0 version or later. For fault codes and their meanings, see the next section in this guide. When the electronic engine control system detects a fault, it broadcasts a message on the datalink. The dash display will show the code "Motor Control Module (MCM) 128," indicating there is an engine fault. The tables that follow are designed to identify the causes of common problems, suggest further checks and appropriate remedies. When dealer service is necessary, this is mentioned in the table.

Important: To read the complete fault code, bring the vehicle to an authorized dealer. Complete fault NOTE: Remember to follow all cautions when troubleshooting the engine. 118 All information subject to change without notice. DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION Problem - The Engine Will Not Crank Cause Remedy The batteries are damaged or weak. Test the batteries. Replace them, if needed. The ignition switch is damaged. Replace the ignition switch. The battery cables are damaged and/or corroded. Replace the battery cables. The starter is damaged and/or worn. Have an authorized repair facility replace the starter. The clutch or transmission is damaged.

Bring the vehicle to an authorized repair facility for service. There is internal damage to the engine. Bring the vehicle to an authorized repair facility for service.