MAN — Man EPA07 MBE 4000 Engine Operator's Manual

AFTERTREATMENT SYSTEM Operating Requirements soot. This process happens during the normal operation cycle of the vehicle; it can occur both passively and actively. Regardless of this, the operator will see no difference in vehicle performance or vehicle control. If the ATS is not capable of completing an over-the-road regeneration due to duty cycle constraints or other restrictions, a parked regeneration may need to occur. Oxidation of the particulate matter is the key to filter performance. This requires that the catalyzing agent (platinum coated passages) are providing optimum enhancement to the oxidation process.

The following requirements must be met, otherwise the ATD warranty may be compromised: NOTICE: Do not use kerosene or fuel blended with used lube oil. The driver will be notified of the need for a DPF regeneration by illumination of the DPF Regeneration Lamp. Refer to section DRIVER ACTIONS . Use Ultra-Low Sulfur Diesel (ULSD) fuel with (15 ppm sulfur content maximum), based on ASTM D2622 test procedure NOTE: If the DDEC VI electronics have not requested the initiation of a parked regeneration (the DPF Regeneration Lamp is not illuminated), the Regen request switch is disabled. Lube oil must have a sulfated ash level less than 1.0 wt %; currently referred to as CJ-4 oil NOTICE: NOTE:

The driver MUST stay with the vehicle throughout the regeneration process. Not following the operating requirements may result in damage to the ATD or accelerated ash plugging of the diesel particulate filter. NOTE: Not all vehicles may be equipped with a Regen request switch due to application or user specification. Parked Regeneration Procedure Regeneration of the ATS is fundamental for the oxidation of 60 All information subject to change without notice. DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION