EPA07 MBE 4000 OPERATOR'S MANUAL NOTE: The procedure will take up to 40 minutes (depends on engine type and the amount of soot accumulated in the filter). To initiate a parked regeneration, perform the following: 1. Keep engine at slow idle (cannot be in PTO mode). The regeneration will take up to 40 minutes. 2. Transmission is in neutral with parking brake ON. The regeneration is completed when the engine returns to low idle and the DPF Lamp remains off. The High Exhaust System Temperature (HEST) Lamp will remain on but the vehicle can be driven. 3. Cycle the parking brake from OFF to ON. NOTE: Air tank pressure must be high enough for the parking brake switch to hold in the OFF position.
If the Parked Regeneration exits and the DPF Lamp remains on, repeat the procedure. If the second try also fails, contact the Detroit Diesel Customer Support Center at (313) 592-5800. 4. Press and release clutch pedal (if equipped with clutch pedal). NOTE: A Parked Regeneration will stop if the key is turned to the OFF position, the vehicle is put into gear, or the parking brake is released. 5. Cycle transmission to DRIVE and back to NEUTRAL (if not equipped with clutch pedal). 6. Hold DPF Switch in the ON position for five seconds and then release (engine speed will increase and DPF Lamp will go out).
Hazardous Applications The MCM should be configured to not allow automatically triggered over-the-road regenerations (DPF Manual Regen Only Enable = Enabled). NOTE: This is for hazardous applications only. All information subject to change without notice. 61 DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION