AFTERTREATMENT SYSTEM There are two CPC options: Particulate filter part number and serial number DPF Stationary Regen Only = 0-Disabled Maintenance DPF Stationary Regen Only = 1-Enabled A high amount of black smoke emitting from the vehicle or illumination of an AWL (Check Engine) or RSL (Stop Engine) are indications of a system problem. Should this occur, refer to the Aftertreatment System Technician's Guide (7SE63), or contact the Detroit Diesel Customer Support Center at 313–592–5800. DPF Stationary Regen Only = 0-Disabled This option allows the DPF Regen Switch to request a parked regeneration if the parked regeneration entry conditions are met.
This option also allows MCM-initiated over-the-road regenerations to occur. DPF Stationary Regen Only = 1-Enabled This option only allows a parked regeneration to occur by using the DPF Regeneration Switch. The MCM will be unable to initiate an active over-the-road regeneration when this option is enabled. Illumination of the Diesel Particulate Filter (DPF) lamp indicates that a parked regeneration is required. There is a need to periodically remove accumulated ash, derived from engine lube oil, from the filter. This ash does not oxidize in the filter during the regeneration process and must be removed through a cleaning procedure.
All Detroit Diesel ATD device equipped engines will illuminate a dashboard warning lamp indicating the need for ash cleaning. For information on this cleaning procedure, refer to the Aftertreatment System Technician's Guide (7SE63), or contact the Detroit Diesel Customer Support Center at 313–592–5800. Service Record It is mandatory that customers or distributors maintain a proper record of the particulate filter servicing and cleaning. This record is an agent to warranty considerations. The record must include information such as: Date of cleaning or replacement Vehicle mileage at the time of cleaning or replacement 62 All information subject to change without notice.
DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION