MAN — Man EPA07 MBE 4000 Engine Operator's Manual

MAINTENANCE Lubricating Oil Filter: The oil filter is a cartridge style element and is located on the front right side of the engine. See Figure 26. If followed correctly, an oil filter change can be performed quickly with minimal oil cleanup. Refer to section “How to Replace the Lube Oil and Filter” in this guide. Item Cooling System Coolant Flush and Fill Proper maintenance of the cooling system is vital to its performance and longevity. The cooling system must, on a constant basis, deal with cavitation, temperature/pressure variations, and continuous threats on the additive package.

Once the additives have been depleted from the coolant, it will only be a matter of time until the engine components suffer. Refer to section “How to Select Coolant“ in this guide. Cooling System Inspection – Inspect the cooling system as follows: HOT COOLANT Figure 26 Lubricating Oil Filter To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. PERSONAL INJURY To avoid injury from slipping and falling, immediately clean up any spilled liquids.

Make a visual check of all lubricating oil lines for wear and/or chafing. If any indication of wear is evident, replace the oil lines and correct the cause. 1. Inspect the radiator, condenser, coolant pump, engine oil cooler, freeze plugs, and heat exchanger for damage and leaks. Check for oil leaks after starting the engine. 2. Check all cooling system pipes and hoses for damage and leaks; 74 All information subject to change without notice. DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION