HOW-TO SECTION Oil analysis may be used to determine whether this interval should be shortened, but it should not be used to lengthen the interval. For detailed information refer to publication Engine Requirements – Lubricating Oil, Fuel and Filters (7SE270), available from authorized Detroit Diesel distributors. 1. Chock the tires, place the transmission in neutral, and set the parking brake. NOTE: Change the engine oil only when the engine is at a temperature of approximately 60°C (140°F). 2. Clean the outside of the oil filter housing, then unscrew the oil filter cap from the housing.
Disposing of Waste Oil — Dispose of used lubricating oil and filters in an environmentally responsible manner, according to federal (EPA) and/or state recommendations. The disposal of waste oil may be best addressed by the engine oil supplier, who may accept responsibility for proper disposal of this material as part of the business of providing lubricant. NOTE: Use care to prevent foreign objects from entering the filter housing. 3. Using a 36-mm socket, unscrew the cap and filter and allow the oil to drain into the housing. After draining, remove the assembly from the housing. (see Figure 33). How to Replace the Lube Oil and Filter Filters are an integral part of the lubricating oil system.
Proper filter selection and maintenance are important to satisfactory engine performance and service life. Filters should be used to maintain a clean system, not to clean up a contaminated system. Replace Lubricating Oil and Filter Drain oil as follows: 84 All information subject to change without notice. DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION