EPA07 MBE 4000 OPERATOR'S MANUAL up to the maximum fill level on the oil dipstick. Requirements – Lubricating Oil, Fuel and Filters (7SE270), available from authorized Detroit Diesel distributors. How to Select Diesel Fuel Detroit Diesel engines in 2007 are designed to operate ONLY on Ultra-Low Sulfur Diesel (ULSD) fuel, see Figure 36. NOTICE: Use only Ultra-Low Sulfur Diesel (ULSD) fuel (15 ppm sulfur content maximum), based on ASTM D2622 test procedure. Using fuel other than ULSD will damage the Aftertreatment Device. Fuel Contamination Generally, fuel contamination occurs as the result of improper fuel handling.
The most common types of contamination are water, dirt, and microbial growth (“black slime”). The formation of varnishes and gums resulting from poor stability or extended storage (“stale fuel”) also affects fuel quality. The best treatment for contamination is prevention by maintaining a clean storage system and choosing a reputable fuel supplier. Figure 36 Quality Fuel quality is an important factor in obtaining satisfactory engine performance, long engine life, and acceptable exhaust emission levels. In general, fuels meeting the properties of ASTM designation D 975 (grades 1-D and 2-D) have provided satisfactory performance.
Supplemental additives are not recommended due to potential injector system or engine damage. Our experience has been that such additives increase operating costs without providing benefit. The fuels used must be clean, completely distilled, stable, and non-corrosive. For more information regarding the significance of these properties and selection of the proper fuel, refer to publication, Engine All information subject to change without notice. 87 DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION