Komatsu — 3.2.5 MACHINE CONTROLS

INSTRUMENTS AND CONTROLS 7 - SLI-SAFE LOAD INDICATOR While lifting or handling a load, check the stability of the machine frequently; if the yellow warning lights come on, maximum attention must be paid while performing manouevres with the equipment control le- ver and travel speed must be reduced if the machine travels on uneven or wavy surfaces. Do not change direction abruptly. Even if the first operational TEST is carried out automatically as soon as the engine is started, check the functionality of the warning lights and of the acoustic alarm every day, by pressing the TEST button on the apposite panel.

The reading of the SLI-Safe Load Indicator refers only to the longitudinal stability of the machine. When the machine is steering or with axle oscillation, the reading of the indicator may be affected by these conditions. Refer to the load charts. If the instrument is faulty or in case of doubts on its functionality, immediately contact your Komatsu Utility Dealer. The SLI-Safe Load Indicator is positioned on the right post of the cab and is clearly visible to the operator. * ( , ) + This instrument comprises warning lights and push buttons having the following functions: a - POWER warning light (1) : when on, indicates that the instrument is correctly powered. NOTE.

This warning light goes out in TRAVEL mode. b - Load curve (2) : constituted by 6 leds (2 green (3-4), 2 yellow (5-6) and 2 red (7-8)) that indicate the risk per- centage variation until reaching the pre-overturning condition (red warning lights). c - TEST button (9) : is used periodically to check the correct functioning of the instrument; when it is pressed, all the warning lights come on and the acoustic alarm sounds for 2 seconds. d - MUTE button (10): allows to deactivate or reactivate the acoustic alarm. 99 DANGER