Komatsu — 3.2.5 MACHINE CONTROLS

INSTRUMENTS AND CONTROLS 11 - REAR AXLE SWING LOCK (Optional) 11-1 TRAVEL AND TRAVEL-WORK OPERATING MODE 1 - The swing of the rear axle will be locked automatically when the inclination of the telescopic boom referred to the frame exceeds approximately 30°. 30° inclination may not correspond to the value displayed by the inclinometer, since the limit inclination angle includes the inclination of the ground; the values indicated by the inclinometer are only valid with the machine positioned on level ground. 2 - The coming on of the warning light indicates that the axle is locked. (See «3.2.2 WARNING LIGHTS»).

Backward or forward travel can only be resumed once the boom has been moved to an overall inclination of less than 30° and after the axle lock warning light has gone out. 3 - Sometimes it may be necessary to lock the axle even if the inclination of the boom is less than 30°; the operator can en- gage the lock manually, by rotating the operating mode se- lector (see «3.2.5 MACHINE CONTROLS») to the WORK position. RKA01000 11-2 WORK MODE If the axle locking system is faulty, this may affect the lift- ing performance of the machine, which may no longer cor- respond to the load charts. This increases the risk of overturning.

DO NOT resume work until your Komatsu Utility Dealer has repaired the malfunction. When changing the operating mode from WORK to TRAV- EL-WORK or TRAVEL on laterally inclined ground with boom inclination below approximately 30°, pay attention to the lateral stability of the machine by releasing the rear ax- le swing lock. 104 ATTENTION boom; when the axle is locked, the warning light (see «3.2.2 WARNING LIGHTS») comes on.

2 - Before starting any load lifting operations, the operator must check the condition of the warning light (see «3.2.2 WARN- ING LIGHTS»); if the machine is malfunctioning and fails to lock the axle, or the warning light remains off, the operator must immediately stop working and contact the Komatsu Util- ity Dealer. DANGER  DANGER