LIFTING LOADS 3.3.1.2 USING THE CHARTS 1 - Find the area in which the load is included on the table corresponding to the machine configuration. NOTE If the load corresponds to the right delimiting line of the area, choose the successive area suitable for a heavier load. The left line of the load area and the upper line represent the stability limits of the machine according to the weight to be lifted. 2 - Following the left profile of the load area, it is possible to ob- tain the maximum length and inclination of the boom accept- able to ensure the longitudinal stability of the machine.
3 - Compare these two values with the data (1) indicated on the boom (2) and on the boom angle indicator (3), in order to de- cide whether or not the manoeuvre can be carried out. 4 - The machine boom has two scale which must used for refer- ence with the load chart in order to assess the lift operation. The boom extension reference scale (1) gives an indication of the boom lenght. The letters “ A G ” correspond to the same letters on the load chart. The concentric scale under the letter “ A ” corresponds to the 1 2 RKAA1000 Do not make the lift operation. c - Look at the boom extension reference scale and the boom angle reference scale and note the readings.
d - Refer to the load chart and use these two values in order to locate the equivalent load zone. e - If the intended load is equal to the value in the equivalent load zone the lift operation can be attempted with caution. Also, if the intended load is less than the value in the equivalent load zone the lift operation can be attempted with caution. 107 fully retracted position of the boom. The concentric scale over letter “G” corresponds to the fully extended position of the boom. 5 - The boom angle reference scale (3) gives an indication of the angle of the boom. For the instructions below in order to as- sess the intended load: a - Position the machine near the load as possible.
For detail see «3.12.6 OPERATING THE MACHINE FITTED WITH FORKS». b - Raise and extend the boom in order to move the work tool into position for the operation. 3 RKAA0990 ATTENTION f - If the intended load is heavier than the value in the equiv- alent load zone the lift operation can not be made. , , ATTENTION - • The areas are defined on the basis of the center of gravity (G) of the load positioned at a distance of 500 mm from the fork shoulders and 500 mm above the upper level of the forks. • If the boom length is included between two letters, the data to be taken in consideration is the legible letter. ATTENTION