TRANSPORTING THE MACHINE ON OTHER VEHICLES 3.9 TRANSPORTING THE MACHINE ON OTHER VEHICLES 3.9.1 LOADING AND UNLOADING THE MACHINE The loading and unloading of the machine on-off the means of transport must be carried out on a flat surface and at a safety distance from the edges of ditches or from the road side. Block the means of transport by positioning wedges before and behind each wheel. Make sure that the ramps are sufficiently strong; if necessary, reinforce them with blocks, in order to prevent any dangerous bending.
Make sure that the ramps have the same length, are firmly anchored to the vehicle, are parallel to each other and per- pendicular to the loading board; the distance between the ramps must be suitable for the machine gauge. Position the ramps with a maximum inclination of 15°. Remove any trace of oil, grease or ice from the ramps and the loading board. 3 Do not change direction when the machine is already on the ramps; if necessary, go down and find the correct direc- tion. 1 - Remove the equipment from the boom. 2 - The machine must get on the ramps with the boom directed forward with respect to the travel direction. RKAA0881 3 - Once the machine has been loaded, apply the parking brake.
4 - Stop the engine and remove the ignition key. 5 - Close the rear window and the cab door. 6 - Keep the machine in the correct position by putting wedges (1) before and behind each wheel. 7- Secure the machine with tie-downs or chains (2) using the anchorage points (3) and (4) provided at the sides of the frame and indicated by the pictograms. 4 8 - Protect the end of the exhaust pipe (5). RKAA1280 , , 140 DANGER