EQUIPMENT 3.12 EQUIPMENT Avoid installing non-approved equipment or equipment that is not provided with specific load charts is- sued or approved by Komatsu Utility. Always make sure that the equipment is installed properly and that the retaining pins are completely en- gaged, and, for the manual type, that the pins are held in place by safety cotter pins. Vibrations and jumps may cause the equipment to fall, with the risk of causing serious injury and even death. This section of the manual illustrates the procedure for attaching and disconnecting the lifting forks and the bucket.
However, the same procedure applies to all pieces of equipment that can be used with equip- ment-carriers with hydraulic or manual coupling. Any equipment with non-standard coupling requires specific equipment-carriers and must be approved by Komatsu Utility. Approved standard equipment includes: lifting forks, loader (for general purpose or for light materials), and 4x1 bucket. Two types of equipment-carriers can be supplied: a - with hydraulic quick coupling b - with manual quick coupling. 3.12.1 INSTALLING EQUIPMENT WITH HYDRAULIC QUICK COUPLING 1 - Press and lock the switch (1) that enables the hydraulic cir- cuit for optional equipment (see «3.2.3 SWITCHES AND PUSH BUTTONS»).
1 RKAA1310 2 - Press the AUX1 button (2). 2 (AUX1) RKAA1320 145 DANGER ATTENTION