Komatsu — 3.12.1 INSTALLING EQUIPMENT WITH HYDRAULIC QUICK COUPLING

EQUIPMENT 3 - Hold the button until the lower coupling pins (3) are fully open. 3 3 RKAA1330 4 - Partially extend the telescopic boom until the quick coupling (4) becomes visible. 6 5 - Operate the machine until aligning the quick coupling with the equipment to be attached. 6 - Using the control lever, tilt the quick coupling forward in order to: a - lower the coupling holes (5) for the fork assembly b - lower the central coupling pins (6) for the loader. 4 5 RKAA1340 7 - Slowly extend the telescopic boom and when the quick cou- pling comes in contact with the equipment to be installed, lift slowly and centre the connections and the equipment.

8 - Using the control lever, draw back the quick coupling until it rests on the lower part of the equipment. RKAA1350 If the equipment moves, this means that the pins are not correctly engaged. 146 9 - Press and hold the AUX2 (7) button until the lower coupling pins (3) are fully engaged. 10 - Disconnect the auxiliary circuits enablement switch (1). IMPORTANT 7 (AUX2) • Before using the equipment, make sure that the lower cou- pling pins are completely engaged by proceeding as fol- lows: 1 - Lower the equipment to the ground, exerting a certain pressure. 2 - Reverse slowly and make sure that the equipment doesn’t move with respect to the equipment-carrier. RKAA1321