EQUIPMENT 3.12.2 INSTALLING EQUIPMENT WITH MANUAL COUPLING The procedure for installing equipment with manual coupling is similar to the procedure for installing equipment with hydraulic coupling. The only difference regards the lower coupling pins (1), which must be extracted and inserted by hand and secured with the safety cotter pins (2). 1 2 RKAA1370 3.12.3 INSTALLING EQUIPMENT REQUIR- ING HYDRAULIC POWER (4X1 BUCKET - FORKS – ROUND BALE GRIPPERS, ETC.) 1 Once the equipment has been connected as described in para- graph «3.12.1 INSTALLING EQUIPMENT WITH HYDRAULIC QUICK COUPLING» and once having verified that both lock pins are fully engaged, stop the engine.
2 1 - Disconnect the delivery and drain pipes (1) and (2) from the quick couplings of the pin control cylinders. 2 - Remove the protection elements of the equipment quick cou- plings and install them on the couplings of the lock pin cylin- ders. RKAA1360 3 - Connect the equipment to the pipes (1) and (2). 4 - Start the engine and lift the equipment so that it is completely visible. 3 5 - Press and lock the optional equipment hydraulic circuit ena- blement switch (3). RKAA1311 6 - Operate the AUX1 button (4) and make sure that the move- ment performed by the equipment corresponds to that speci- fied on the adhesive plate supplied with the equipment.
7 - If the movement doesn’t correspond to the indications given, lower the equipment to the ground, stop the engine and in- vert the connection of the delivery and drain pipes. 4 (AUX1) RKAA1322 147