Komatsu — 3.12.6.3 STACKING THE LOAD

EQUIPMENT 10 - Once the stability of the machine has been ascertained, fold the equipment further and, using the control lever, retract the boom to release the load and continue the manoeuvres until the boom is retracted and lowered at 30 cm from the ground. 11 - Disengage the parking brake, select the TRAVEL-WORK op- erating mode and if the machine is equipped with stabilizers raise them completely. RKA01970 3.12.6.2 TRANSPORTING THE LOAD 1 - Engage the reverse gear and move the machine away from the loading area, making sure that there are no people or obstacles in the area.

2 - If necessary, level the frame (if the frame levelling device is provided) before starting to move towards the un- loading area. 3 - If necessary, select the steering mode (two-wheel, round or crab steering) (see «3.2.5 MACHINE CON- TROLS») and start travelling slowly in order to get as near the unloading area as possible, always in perpen- dicular position. 3.12.6.3 STACKING THE LOAD 1 - With the machine in TRAVEL-WORK operating mode, move perpendicularly and get as near the unloading ar- ea as possible. 2 - Use the water level to check if the frame needs levelling; if necessary and if the frame levelling device is pro- vided, level the frame.

3 - If the machine is equipped with stabilizers, lower them until raising the front tyres a few centimeters from the ground, always maintaining the level condition achieved in step 2. 4 - Apply the parking brake (1) and move the gearshift-reverse lever (2) to NEUTRAL (N). . / 151