Komatsu — 3.12.6.1 FORKING A LOAD

EQUIPMENT 5 - Shift the reverse lever (3) into neutral. . / 6 - Select the WORK operating mode and make sure that the forks are as wide as possible and centered with respect to the equipment-carrier plate; if necessary, widen the forks, making sure that there are side retainers to prevent the load from slipping. 7 - Swing the quick coupling until the forks are in horizontal posi- tion. 1 RKAA0921 8 - Extend and lower the boom until the forks held the load firm- ly. RKA01950 150 9 - Lift the load slowly a few centimeters by folding the equip- ment, to check the stability of the machine on the SLI-Safe Load Indicator (see «3.2.5 MACHINE CONTROLS» 7 - SLI- SAFE LOAD INDICATOR).

NOTE • If the machine has reached or exceeds the stability limit, lower and release the load and if possible move the ma- chine nearer, in order to reduce the boom length and the operating angle. • If the stability limit is reached notwithstanding this ma- noeuvre, the operation CANNOT be performed. RKA01960 KA01960