Komatsu — 3.12.6.1 FORKING A LOAD

EQUIPMENT 3.12.6 OPERATING THE MACHINE FITTED WITH FORKS 3.12.6.1 FORKING A LOAD The machine must move in TRAVEL-WORK operating mode, with boom lowered and completely retracted. The other forking operations must be carried out in WORK operating mode. Before starting work, it is important to know the mass of the load to be handled and to consult the load chart corresponding to the machine configuration (with or without stabilizers) (see «3.3 LIFT- ING LOADS»). If the mass of the load isn’t known, proceed as indicated below. 1 - Get as near the load as possible, perpendicularly, and select the TRAVEL-WORK operating mode with the selector (1).

2 - Use the water level to check if the frame needs levelling; if necessary, and if the frame levelling device is provided, level the frame. 1 RKAA0911 3 - If the machine is equipped with stabilizers, lower them until raising the front tyres a few centimeters from the ground, al- ways maintaining the level condition achieved in step 2. RKA01940 4 - Apply the parking brake (2). 149 ATTENTION