Komatsu — 3.12.7 PREPARING THE MACHINE FOR TRAVELLING ON ROADS

EQUIPMENT 3.12.7 PREPARING THE MACHINE FOR TRAVELLING ON ROADS When tipping the forks in order to position them correctly for a transfer or for the normal use of the ma- chine, the necessary operations must be carried out by two persons; carefully check the holding points, since there is the risk of crushing and cutting the upper and lower limbs. When tipping the forks, check their width and adjust it, if 153 8 - Lower the load until resting it where it must be unloaded and, after making sure that it is stable, release it by lifting and re- tracting the boom and therefore disengaging the forks. DANGER • Do not move the machine to disengage the forks.

9 - Retract and lower the boom completely before raising the stabilizers, if provided; release the parking brake before se- lecting the operating mode (TRAVEL or TRAVEL-WORK). RKA02010 DANGER DANGER The machine equipped with forks has two safety locks (1); these are constructed and positioned in such a way as to be always in- tegral with the equipment holder (2), even when the forks (3) are operating. Fastening is achieved with two pins (4) that engage in the safety retainers (1) and in the equipment holder (2); the two pins are held in position by safety pins (5). For travelling on roads, proceed as follows: 1 - Remove the safety pins (5).

2 - Extract the pins (4) and tip the retainers (1) towards the front. 3 - Tip the forks (3) and engage them in the retainers (1). 4 5 1 2 3 RKAA2330 NOTE necessary. 4 - When the back of the forks (3) is positioned against the seats of the retainers (1), insert the pins (4) and secure them with the safety pins (5). 3 5 1 DANGER • The safety retainers must be installed as indicated in the fi- gures; overturning the retainers may lead to serious dan- ger for the operator and for anyone in the vicinity. 4 RKAA2340 DANGER