Komatsu — 3.12.8.2 LOADING HEAPED AND LEVEL MATERIAL

EQUIPMENT 3.12.8 USING THE MACHINE AS A LOADER Fit the machine with an approved bucket, that is, one that is suitable for the job on hand and, above all, for the prod- uct to be handled or loaded. When the bucket is used to organise the work area, keep the bucket bottom parallel to the ground and work at low speed to avoid excessive strain on the bucket front edge. Stacking operations must be carried out with the boom ful- ly retracted and the bottom of the bucket parallel to the ground. Load the bucket evenly and avoid positioning all the load to one side or with unbalanced weight, as these conditions may adversely affect the stability of the machine during travel and unloading.

3.12.8.1 ORGANIZING THE WORK AREA When using the loader, keep the boom as low as possible. In all other situations the movements of the machine must be re- duced to the minimum, exploiting the steering capacity of the ma- chine as much as possible. 3.12.8.2 LOADING HEAPED AND LEVEL MATERIAL loading; proceed as follows: 1 - 154 ATTENTION If after a first inspection the area results to be uneven, encum- bered with big obstacles or characterized by considerable height differences, before starting work it is advisable to level the ground as much as possible, both for the machine and for the vehicles to be loaded.

This preliminary operations will make work quicker, ensure better results and at the same time reduce the operator’s stress and the straining of the machine components; furthermore, this will con- siderably reduce the time necessary to load the trucks. To clear the area of any obstacles, the equipment must be posi- tioned as shown in the picture. IMPORTANT RKA02140 RKA02140 w the operator starts rds the heap base. RKA02150