OPERATIONS IN CASE OF FAILURE tery, and avoid producing sparks. The battery electrolyte is made of diluted sulphuric acid that may corrode clothes and even the skin; in case of con- tact with this fluid, immediately rinse the involved part with plenty of water. If the acid gets into the eyes, immediately rinse with plenty of water and consult a doctor without delay. REMOVAL When working on the battery, always wear goggles and gloves. When removing the battery, disconnect first the earth cable (–); when installing the battery, connect first the positive cable (+).
If a tool makes contact with the positive terminal and the machine structure at the same time, this may generate sparks with consequent risk of explosion. INSTALLATION Carefully tighten the connection terminals, since false con- tacts may generate sparks with consequent risk of explo- sion. RKA01160 161 3.14.4 IF THE ENGINE FAILS TO START BECAUSE THE BATTERY HAS RUN DOWN DANGER • When checking or carrying out any operation on the bat- tery, stop the engine and make sure that the ignition switch is in position «O». • The battery produces hydrogen, which may explode. Do not use naked flames and do not smoke near the bat- RKA00380 DANGER