OPERATIONS IN CASE OF FAILURE 3.14.4.1 STARTING WITH BOOSTER CABLES When using the machine in cold climates, before starting it with a different power source (and therefore with booster cables), make sure that the electrolyte isn’t frozen, as the battery may catch fire. Before starting the machine or recharging the battery, let the electrolyte melt down and make sure that there are no leakages in the battery. It is absolutely forbidden to start the engine by shorting together the terminals of the starter; the con- nections of the booster cables must be carried out as indicated below. When starting the engine with the aid of another machine, connect the batteries in parallel.
When connecting the cables, avoid any contact between the positive cable (+) and the negative cable(–). When starting the engine with booster cables, always wear safety goggles. Take care to avoid any contact between the machine to be started and the machine used as starting aid, in order to avoid sparks and therefore the explosion of the hydrogen produced by the batteries. The explosion of the battery causes serious damage and injury. Take care not to switch the ignition cables. Connect the ground cable (–) last to the main ground block of either the engine or the machine to be started.
Remove the cables with great care; prevent the cables disconnected from the battery from touching oth- er parts of the machine, in order to avoid the explosion of the hydrogen. IMPORTANT Cables and pliers must be suitable for the current load that must be transferred. The battery to be used for the starting must have greater capacity or at least the same capacity as the battery of the machine to be started. Make sure that the cables and pliers are neither corroded, nor damaged. Make sure that the pliers hold the terminals firmly. CONNECTING THE CABLES AND STARTING THE ENGINE 1 - Make sure that the ignition key is in position « O ».
2 - Connect the positive poles (+) of the two batteries with each other (A). 3 - Connect the cable of the negative terminal (-) of the charged battery to the ground block of the machine to be started (B). 4 - Start the engine of the machine that supplies current and in- crease its speed. 5 - Start the engine of the failed machine. (See «3.6.2 START- ING THE ENGINE»). REMOVING THE CABLES When the engine has started, remove the cables in the reverse order with respect to their connection. 1 - Disconnect the negative cable (-) from the ground block of the engine that has been started and then from the battery (B).
2 - Disconnect the positive cable (+) first from the battery used for the starting and then from the exhausted battery (A). Charged battery Depleted battery Engine block to be started 162 DANGER Charged Depleted battery battery Engine block to be started