Komatsu — 4.2.2 NOTES REGARDING THE HYDRAULIC SYSTEM

MAINTENANCE NOTES 4.2.1.3 FUEL Always use fuel suitable for the engine. Other fuels with different specifications may damage the engine or re- duce its power. Always refuel at the end of the workday. When refuelling, make sure that there is no water on the fuel drum cover and take care not to draw condensate from the drum bottom. If fuel runs out, or if the fuel filter has been replaced, it is necessary to bleed the circuit. 4.2.2 NOTES REGARDING THE HYDRAULIC SYSTEM Be extremely careful when performing maintenance operations on the hydraulic system, since soon after work the oil is very hot. The circuit is pressurized not only during work, but also at the end of work.

The maintenance operations required for the hydraulic system are the following: 1 - daily check of the oil level in the tank; 2 - periodical change of the oil filter; 3 - periodical change of the oil and cleaning of the intake filter. Always bleed the circuit after changing the oil filter or the oil. When a component is removed from the circuit, check the gaskets and O-rings and change them if they are damaged. When a cylinder or a component of the hydraulic circuit is removed, after reassembly bleed the circuit by pro- ceeding as follows: 1 - start the engine and let it idle; 2 - extend all the cylinders 4-5 times, stopping them at approx.

100mm from the end of stroke; 3 - With the machine in WORK mode, lift the boom to the maximum height and slowly extend and retract it completely. 4 - Once the boom is completely retracted, slowly extend all the cylinders completely 3 or 4 times. 171