MAINTENANCE PLAN 4.7.1 WHEN REQUIRED 4.7.1.a CHECKING THE BATTERY ELECTROLYTE LEVEL – INSPECTING TERMINALS AND CABLES IMPORTANT It is advisable to add distilled water before starting work, in order to prevent it from freezing. Before putting back the cell plugs, make sure that the breather holes are not clogged. Make sure that the connection terminals and cables are not oxidized; if necessary, clean them and cover them with an- ti-oxidation grease. 189 DANGER • Carry out this check with the machine parked on level ground. • Check the level only after stopping the engine and if neces- sary add distilled water only before starting work. • Always wear safety goggles and waterproof gloves.
• To prevent gas explosions, do not use naked flames, do not smoke and avoid producing sparks due to short cir- cuits. • The battery electrolyte is dangerous; in case of contact with the eyes or skin, rinse with plenty of water and consult a doctor without delay. 1 RKAA2170 DANGER The battery (1) can be reached after opening the engine hood. The electrolyte level in each cell must be about 6 mm above the plate edge; if necessary, remove the cell plugs and top up using exclusively distilled water. If, on the contrary, the level is low because some fluid has been spilled, add electrolyte with concentration suitable for the ambient temperature. (See «3.10.3 BATTERY»).
NOTE • When adding distilled water or electrolyte, do not exceed the level indicated. This would shorten the service life of the battery and may cause the electrolyte to overflow. RKAA2180