Komatsu — 4.7.1.i CHECKING THE FUEL LEVEL

MAINTENANCE PLAN 4.7.1.f CHECKING THE WINDSHIELD WIPER BLADES The windshield wiper blades should be checked once the windshield wipers have stopped working, by verifying the conditions of the windshield. If any lines are left on the windshield after washing and wiping it, this means that the scraping wire has deteriorat- ed and it is therefore necessary to change the blades. 4.7.1.g LUBRICATING THE CAB DOOR AND ENGINE HOOD HINGES Cab door and engine hood hinges should be lubricated when a squealing noise is heard on opening or closing the cab door or engine hood or when signs of oxidation are found on the shoulder washers or on the pivots.

The lubrication procedure consists in injecting grease into the nipples provided on the hinge axes. For further information on the appropriate grease to use, see «4.3 FUEL, COOLANT AND LUBRICANTS». Inject grease until all the residual old grease has come out. After lubrication, remove all the grease that has come out and clean the area. 4.7.1.h LUBRICATING THE FORK SUPPORT ROD The fork support rod should be lubricated when the widthwise movement of the forks is difficult. Use a brush to lubricate the support rod. For further information on the appropriate grease to use, see «4.3 FUEL, COOLANT AND LUBRICANTS». 4.7.1.i CHECKING THE FUEL LEVEL room for the fuel to expand.

194 ATTENTION DANGER • When refuelling the machine, avoid spilling fuel, since this may cause a fire hazard. If fuel is spilled, wipe it immediate- ly. • Fuel is flammable; do not use naked flames and do not smoke when refuelling. • Hold the fuel gun constantly in contact with the filler. To check the fuel level, use the fuel gauge positioned on the dashboard. Do not fill the tank (1) completely, but leave enough RKAA1450 DANGER IMPORTANT • It is advisable to refuel after work, in order to avoid the for- mation of condensate. • After refuelling, screw the filler cap (2) thoroughly and lock it. 2 1 RKAA2190