Komatsu — 4.7.1.e CHECKING THE WINDSHIELD WASHER FLUID LEVEL

MAINTENANCE PLAN 4.7.1.d FUSES AND RELAYS – CHECK AND CHANGE IMPORTANT Before changing a fuse, make sure that the ignition key is in position « ». If the fuses are oxidized, corroded or do not fit perfectly in their seat, replace them only with new fuses having the same capacity. If the engine does not run when the ignition switch is turned to position « » START, check the main fuse and replace it if necessary. CENTRAL UNIT FUSES AND RELAYS Fuses and relays are grouped on a single base that is positioned on the inside of the cab’s right wall. The central unit can be reached by removing the panel (1).

For information on the capacity of the fuses and relays to be re- placed, see «3.4.1 CENTRAL UNIT FUSES AND RELAYS». 1 RKAA1021 ENGINE LINE FUSES AND RELAYS 1 The fuses and relays are grouped on a single base positioned in- side the engine compartment and can be reached by removing the cover (1). For information on the capacity of the fuses and relays to be re- placed, see «3.4.2 ENGINE LINE FUSES AND RELAYS». RKAA0721 4.7.1.e CHECKING THE WINDSHIELD WASHER FLUID LEVEL If there is air in the windshield washer fluid, check the washer fluid level in the reservoir (1). If necessary, add detergent of the type used for cars.

While topping up, be careful to prevent dust from getting into the reservoir. 1 Quantity of detergent to be mixed with water Proportions vary according to ambient temperature. Before top- ping up, it is advisable to dilute the detergent with water according to the quantities indicated in the following table. RKAA1430 193 Area, season Proportions Freezing temperature Normal Detergent 1/3 Water 2/3 -10 °C Cold area - winter Detergent 1/2 Water 1/2 -20 °C Very cold area - winter Undiluted detergent -30 °C