MAINTENANCE PLAN 4.7.2.c CHECKING THE ENGINE COOLANT LEVEL id level in the radiator. (See «4.7.2.d CHECKING THE RADIATOR FLUID LEVEL»). IMPORTANT The upper MIN. and MAX. marks indicate the level reached by the coolant after expansion, at operating temperature. 4.7.2.d CHECKING THE RADIATOR FLUID LEVEL the filling hole. IMPORTANT If the level of fluid in the radiator is low and the expansion tank is filled with coolant, check for tightness and make sure that there are no air leakages from the pipe that con- nects the radiator to the expansion tank. If the problem persists, contact your Komatsu Utility Deal- er.
197 DANGER • Do not remove the radiator cap; the coolant level must be checked with cold engine, through the expansion tank. The coolant level must be checked on the expansion tank (1), which can be reached after opening the engine hood. The check must be carried out with cold engine and the coolant level must be above the lower MIN. mark. If the level is near the MIN. mark, fill the tank with coolant, and if the level decreases considerably and constantly, check the radia- tor-engine seals and the radiator body for leaks and check the flu- 1 RKAA1480 DANGER DANGER • Carry out this check with the machine parked on level ground.
• Do not remove the radiator cap when the fluid is hot, since the fluid may be sprayed out of the radiator and cause burns. • Loosen the cap slowly to release any residual pressure. The radiator cap can be reached after opening the engine hood. Remove the cap (1) and make sure that the fluid level is very near 1 RKAA1490 DANGER