Komatsu — 4.7.3.a LUBRICATING THE ARTICULATED JOINTS AND THE PADS

MAINTENANCE PLAN 4.7.3 MAINTENANCE EVERY 50 HOURS OF OPERATION OR EVERY 2 WEEKS These maintenance operations should be carried out together with those to be performed every 10 HOURS. 4.7.3.a LUBRICATING THE ARTICULATED JOINTS AND THE PADS The compensating cylinder must be lubricated on the head side from under the machine; always apply the parking brake and remove the ignition key. The lifting cylinder must be lubricated on the base side with partially lifted boom and grease nipple posi- tioned beside the safety valve. IMPORTANT Clean the grease nipples thoroughly before applying the greasing pump.

After lubrication, remove all the contaminated grease that may have spread out and clean the area. If the machine is used in difficult conditions, carry out these operations more frequently than usual. 1 - Park the machine on firm and level ground, as described in «3.7.1 PARKING ON LEVEL GROUND». 2 - Make sure that the gearshift-reverse lever (1) is in neutral po- sition (N) and apply the parking brake (2). 1 3 - Stop the engine, proceeding as described in «3.8 STOPPING THE ENGINE». ( N ) ( N ) 4 - Remove the ignition key. The ignition key must be kept by the person in charge of maintenance until the end of work. 5 - Lubricate using a syringe filled with the prescribed grease.

(See «4.3 FUEL, COOLANT AND LUBRICANTS» and the maintenance chart). RKAA1274 2 RKAA0875 200 DANGER