MAINTENANCE PLAN rection (b). 4.7.2.h CHECKING AND ADJUSTING THE PARKING BRAKE and proceed up the slope with 20% gradient. 3 - Stop the machine with the service brakes and shift the re- verse lever (1) to neutral (N). 4 - Apply the parking brake (2) (lock position), release the serv- ice brakes slowly and make sure that the machine does not move. ADJUSTMENT 2 1 - Press the service brake pedal, release the brake lever and rotate the lever end (2) by giving it 2 or 3 anticlockwise turns. 2 - Apply the parking brake and check again. RKAA0874 199 4.7.2.g CHECKING THE SERVICE BRAKES IMPORTANT • Perform this check on firm, level ground, with no people or obstacles around.
This checking procedure should be carried out with the machine in TRAVEL operating mode, i.e. the compulsory mode for circula- tion on roads. 1 - Release the parking brake (1) and start the engine. (See «3.6.2 STARTING THE ENGINE»). 2 - Engage the 2nd (a) gear and select the FORWARD travel di- 1 RKAA1510 3 - Press the brake pedal thoroughly and accelerate until reach- ing the maximum engine speed. In this condition, the machine must not move. a b DANGER • The machine may cause accidents if it moves during the test. In this case, release the accelerator immediately and apply the parking brake.
RKAA1273 DANGER IMPORTANT • During running-in, check the efficiency of the parking brake after the first 100 hours of operation. CHECK Check conditions: • Tyre pressure in accordance with the prescribed values. • Road surface dry, compact, with a gradient of approx. 20%. • Machine in operating conditions without load. 1 - Start the engine, (see «3.6.2 STARTING THE ENGINE»). 2 - Align the machine in travel position on a straight road section 1 (N) RKAA1274